华硕路由器 OpenWRT Stable 固件更新v24.10.2

Master

华硕路由器 OpenWRT 固件更新，此为稳定版v24.10.2，有需要的朋友可以试试。



包含机种
RT-AX52
RT-AX59U
TUF-AX4200
TUF-AX6000



下载链接: https://pan.baidu.com/s/1rRZ3DbBaxoDzo6RoFCIJNw
提取码: r89f



注意事项：
1. 刷机有风险，请谨慎刷机

2. 从ASUSWRT首次刷OpenWRT，请先刷 xxx-initramfs-kernel.bin，再刷 xxx-squashfs-sysupgrade.bin

3. OpenwrtFw--AsusFw相互转换方法如下

Installation
-----------------------------------------------------------
Install openwrt image:
1. Download the OpenWrt initramfs image. Copy the image to a TFTP server
   reachable at 192.168.1.70/24. Rename the image to rtax59u.bin.

2. Connect the PC with TFTP server to the RT-AX59U.
   set a static ip on the ethernet interface of your PC. (ip address: 192.168.1.70, subnet mask:255.255.255.0)
   Conect to the serial console, interrupt the autoboot process by pressing '4' when prompted.

3. Download & Boot the OpenWrt initramfs image.

   $ setenv ipaddr 192.168.1.1
   $ setenv serverip 192.168.1.70
   $ tftpboot 0x46000000 rtax59u.bin
   $ bootm 0x46000000

4. Wait for OpenWrt to boot. Transfer the sysupgrade image to the device
   using scp and install using sysupgrade.

   $ sysupgrade -n <path-to-sysupgrade.bin>
----------------------------------------------------------------------------------
Revert to stock firmware:
1: Download the rt-ax59u firmware from ASUS official website. Save the firmware to tftp server directory and rename  to RT-AX59U.trx

2: Connect the PC with TFTP server to the RT-AX59U.
   Set a static ip on the ethernet interface of your PC. (ip address: 192.168.1.70, subnet mask:255.255.255.0)

3: Conect to the serial console,  power on again,  interrupt the autoboot process by pressing '4' when prompted.
  $: ubi remove linux
  $: ubi remove jffs2
  $: ubi remove rootfs
  $: ubi remove rootfs_data
  $: ubi create linux 0x45fe000
  $: reset
  then the dut will reboot,interrupt the autoboot process by pressing '2' when prompted.
            2: Load System code then write to Flash via TFTP.
             Warning!! Erase Linux in Flash then burn new one. Are you sure?(Y/N)
             $: enter y
  you will see the follow, type enter directly:
        Input device IP (192.168.1.1) ==:
        Input server IP (192.168.1.70) ==:
        Input Linux Kernel filename (RT-AX59U.trx) ==:

4: wait for the device run up

微信扫一扫，阅读更方便^_^